Disc-cutter induced rock breakage mechanism for TBM excavation in rock masses with different joint shear strengths

Abstract

When tunnel boring machines (TBMs) excavate through jointed rock masses, the cutting efficiency is strongly affected by the shear strength of joints, the mechanism of which, however, remains poorly understood. In this study, a series of disc-cutter indentation tests were conducted on granite rock mass specimens with different joint shear strengths. During the indentation, the cracking process was recorded by a digital image correlation (DIC) system. The deformation and strength of specimens, cracking behavior, rock breakage mode and cutting efficiency were quantitatively investigated. In addition, to investigate the combined effects of joint shear strength, orientation and spacing on the rock breakage mechanism, numerical rock mass models were established based on a particle flow code PFC2D. Experimental results reveal that the cracking of primary and secondary cracks changes from the mixed shear-tensile to tensile mode in the initial stage, while the joint shear strength does not affect the cracking mode in the subsequent propagation process. The rock breakage mode is classified to an internal block breakage mode, a cross-joint breakage mode and a cutters-dependent breakage mode. The cross-joint breakage mode is optimal for improving the cutting efficiency. Numerical simulation results reveal that the increase in the joint shear strength changes the internal block breakage mode to cross-joint breakage mode for rock masses of particular ranges of joint orientation and spacing. These findings provide basis for improving the TBM cutting efficiency through jointed rock masses.

Keywords

• Indentation test
• Joint shear strength
• Disc cutter
• Rock breakage mechanism
• Cutting efficiency