Microstructural investigation of direct laser deposition of the Ti–6Al–4V alloy by different melt pool protection conditions

Abstract

Titanium alloys require a special protecting atmosphere during the fabrication process due to their strong affinity with oxygen and nitrogen elements at high temperatures. In this study, the effects of different protection conditions on microstructure, phase characteristics, interstitial elements absorption and microhardness of additively manufactured Ti–6Al–4V alloy by direct laser deposition method have been investigated. Fabrication of specimens with similar laser parameters was carried out in three different protection conditions consist of air, closed box and argon shower. Characterization of samples was performed by utilization of OM, SEM, XRD, inert gas fusion method, micro-hardness and tensile strength analysis. Results indicated that fabrication of samples in an air atmosphere without proper protection leads to 2.5% spherical porosities, TiO2 and TiN formation in top layers, changing the c/a ratio from 1.59 to 1.61, absorption of 1870 and 500 ppm oxygen and nitrogen and 155 HV increment in micro-hardness value. Also, uncommon semi-globular microstructure in different locations of samples has been observed. The special protective atmosphere provided by argon shower led to 6.3% spherical porosities, negligible lattice parameter variation and martensite microstructure formation. It was found that in the optimal protection condition that was provided by a closed box, the typical basketweave microstructure with less than 1% porosity and 960 and 140 ppm oxygen and nitrogen absorption were achieved, which did not exceed the standard limits. In addition, the mechanical properties of UTS tensile strength, yield strength and elongation, were obtained 1042, 893 MPa and 13.2% respectively.

Keywords

• Additive manufacturing
• Ti–6Al–4V alloy
• Microstructure
• Melt pool protection
• Direct laser deposition