Relationship between Pelvic Dimensions and Maximum Traction Forces Required during Parturition in Holstein Cows Using a Biomechanical Obstetric Simulator

Abstract

The primary aim of this study was to investigate the effect of the pelvic dimensions of Holstein cows on the traction forces during parturition. Additionally, the relationship between calf measurements and traction forces was explored. For this purpose, a modified in vitro biomechanical model simulating obstetric tractions was used. For the requirements of the experiment, six bone pelvises of deceased Holstein cows were collected based on their estimated pelvic inlet area (EPA) and prepared. Additionally, six stillborn calves were collected based on their body weight (BW). The parameters of the pelvic inlet and cavity were measured using computed tomography (CT). Using the simulator, every calf was pulled in a random order through all pelvises, realizing a total of 36 obstetrical tractions, and the required forces were documented with appropriate software. In each extraction, three peaks of forces were recorded, with the first peak occurring at the entrance of the elbows into the maternal pelvic cavity, the second peak at the entrance of the thorax, and the third at the entrance of the calf’s pelvis. Logistic regression revealed an exponential relationship between pelvic parameters and traction forces for the entrance of the elbows and the pelvis, with the recorded forces being higher in the two smallest pelvises and stabilizing at a lower level thereafter, while for the entrance of the thorax, the correlations were either exponential or linear. The adjusted coefficients of determination (r2) were generally above the threshold of 0.5 for the entrance of the elbows and pelvis and lower (0.3–0.4) regarding the thorax and were statistically significant (p 2 of 0.72 for the entrance of the elbows using the pelvic diagonal and calf’s body weight, an r2 of 0.62 using the pelvic area and calf’s thoracic circumference, and an r2 of 0.75 using the pelvic diagonal and calf’s fetlock joint width. In conclusion, under the conditions of the present experimentation, the applied traction forces were mainly influenced by the pelvic dimensions in an exponential manner, whereas the calf body measurements showed a weaker effect. Based on these findings, critical cut-off points exist, different for every pelvic parameter, below which a significant increase in the required traction forces is expected.

Keywords

• parturition
• traction forces
• dairy cattle
• pelvic measurements