Increasing of Pulsed Laser Source Peak Power by Use of Ring Fiber-Optic Delay Line

Abstract

At the present time, developing of autonomous laser systems requires increasing of the output power of the laser sources used in composition of those systems and at the same time reducing of the energy usage in the system. The possibility of increasing output peak power of pulsed laser sources by using the method of synchronous non-coherent beam combining in ring fiber-optic delay line is considered by authors. Objective of this work was estimating energy effectiveness of laser systems, which based on this method.General constructing method of the laser pulsed laser source with ring fiber delay line is considered, its block diagram and the general operating principle of similar systems are presented. Two versions of laser systems based on the described method of beam combining are presented: using an optical combiner and an optical switch; using fiber welding instead of a combiner and an optical switch. The graphical dependence of the energy effectiveness on the number of circulations in ring fiber-optic delay line is obtained for both versions of laser systems.As a result of the analysis of the considered devices operation, it was shown that considered systems allow to obtain increasing the peak power of a laser pulse without increasing the power supply, also the system, that use welded fi instead of the optical combiner, has greater effi than system with optical combiner.

Keywords

• laser source
• peak power
• ring fiber-optic delay line
• energy effectiveness
• optical losses