A 1T2R High-Sensitivity and Dual-Channel Transceiver for Backscatter Communication Systems

Abstract

Owing to the rapid development of the ambient Internet of Things (IoT) industry, Backscatter Communication Systems (BCS) require higher receiver sensitivity for large-scale IoT scenarios than traditional Radio Frequency Identification (RFID) systems. This paper proposes a method of using Multiple-Input Multiple-Output (MIMO) technology to compensate for reflected signals in the 920 MHz backscatter communication systems. The researcher first created a MATLAB model to verify the theoretical feasibility and then built a One-Transmitter Two-Receiver (1T2R) BCS transceiver system compatible with the EPC global protocol for practical verification on LabVIEW. The ITIR and 1T2R tests were conducted using the National Instrument (NI) USRP-2952R device, the directional antennas, and the standard RF electronic tags. Through the process of superimposing and utilizing the phase shift between the two reflected carriers, it has been confirmed that the overall signal strength can be enhanced from 2.2 mV to 4.13 mV and 4.37 mV (nearly reaching 4.70 mV by using two Rx antennas in ideal conditions). After calculation, this advancement increases signal strength from −40.14 dBm (when using a single Rx antenna) to −34.18 dBm (when using two Rx antennas). The improvement in signal strength can provide a gain of 5.96 dB to the backscatter communication systems. Experimental results demonstrate that utilizing MIMO technology to the backscatter communication systems can effectively enhance the sensitivity of the receiver at 920 MHz.

Keywords

• 1T2R transceiver
• ambient Internet of Things
• backscatter communication systems
• radio frequency identification
• multiple-input multiple-output