OPTIMIZATION OF TECHNOLOGY IN PROCESSING THE LANDMARK ”SUCTION CAP” WITH NX 7.5 SOFTWARE

BLANARU Viorel; EFTIMIE Dorin; ŞOMOIAG Adrian

Journal of Industrial Design and Engineering Graphics (Jun 2011)

OPTIMIZATION OF TECHNOLOGY IN PROCESSING THE LANDMARK ”SUCTION CAP” WITH NX 7.5 SOFTWARE

BLANARU Viorel,
EFTIMIE Dorin,
ŞOMOIAG Adrian

Affiliations

BLANARU Viorel: graduate student (AACDMET) at Engineering Faculty of Braila, ,,Dunarea de Jos’’ University of Galati
EFTIMIE Dorin: Ph.D., Assist. Professor at Engineering Faculty of Braila, ,,Dunarea de Jos’’ University of Galati
ŞOMOIAG Adrian: graduate student (AACDMET) at Engineering Faculty of Braila, ,,Dunarea de Jos’’ University of Galati

Journal volume & issue: no. 6

Abstract

Read online

This paper is to present the optimization processing of the landmark suction cap with NX software 7.5. It has been done the modeling CAD of the landmark 3D. It has been projected the technology to execution CAM of the landmark where they revealed aspects of processing sequence and technological parameters.

design, optimization, CAM.

Published in Journal of Industrial Design and Engineering Graphics

ISSN: 1843-3766 (Print); 2344-4681 (Online)
Publisher: SORGING
Country of publisher: Romania
LCC subjects: Technology: Building construction: Architectural engineering. Structural engineering of buildings; Technology: Engineering (General). Civil engineering (General): Engineering design
Website: http://sorging.ro/jideg/

About the journal

Abstract

Keywords