Buildings (Mar 2023)

Preliminary Reactivity Test for Precursors of Alkali-Activated Materials

  • Sâmara França,
  • Leila Nóbrega Sousa,
  • Marcos Vinicio de Moura Solar Silva,
  • Paulo Henrique Ribeiro Borges,
  • Augusto Cesar da Silva Bezerra

DOI
https://doi.org/10.3390/buildings13030693
Journal volume & issue
Vol. 13, no. 3
p. 693

Abstract

Read online

Alkali-activated materials (AAMs) result from the dissolution process and polycondensation of precursors in high pH solutions. This material is considered alternative cement with similar properties and lower environmental impact than Portland cement. However, AAMs are subjected to the same standardization applied to cement-based materials since no formal methods exist to characterize this material and/or the precursor reactivity. Therefore, this work aims to develop a method to characterize the reactivity of the main precursors used to produce AAMs. Hence, the precursors were assessed in two steps after chemical, physical, and mineralogical characterization. The first step evaluated the crystallinity change of the material after the acid attack by mixing 1 g of each material in 100 mL of 1% HF solution for 6 h at ambient temperature. The crystallinity change was evaluated by comparing the X-ray diffraction of the materials before and after the acid attack. The second step involved evaluating the formation of geopolymerization products in the pastes of studied precursors through FTIR test. The pastes were produced with Na2SiO3 and NaOH as activators. After 28 days of curing, the pastes were submitted to a FTIR test for structural analysis. This method was tested evaluating the reactivity of traditional precursors for alkali activation (i.e., silica fume (SF), blast furnace slag (BFS), and metakaolin (MK)), in addition sugarcane bagasse ash mechanically treated (SCBAM) and sugarcane bagasse ash mechanically and heat treated (SCBAMH) since SCBA is a promising precursor for alkali activation. Considering the crystallinity change of precursors (step 01), the formation of geopolymerization products (step 02), and the chemical composition of precursors (preliminary characterization), it could be concluded that: (i) surface area is not relevant to materials with small particle size (2/Al2O3 ratio of 2 to 5. Also, it could be concluded that SF and SCBAMH do not exhibit adequate reactivity while BFS, MK, and SCBAM can be classified as reactive precursors.

Keywords