Optimization of hot-rolling parameters for a powder metallurgy Ti–47Al–2Cr–2Nb-0.2W alloy based on processing map and microstructure evolution

Abstract

In this work, a two-stage rolling method with varied temperature and strain rate was proposed for powder metallurgy (PM) Ti–47Al–2Cr–2Nb-0.2W alloy sheets based on the guidance of processing map and microstructure evolution. Compared with conventional rolling at a high temperature and a low strain rate, the TiAl alloy exhibited enhanced plastic deformability through the implementation of the two-stage rolling method, resulting in a higher cumulative true strain. Microstructure analysis revealed significant grain refinement in the rolled sheet. During the first stage of hot rolling with high temperatures and low strain rates, the softening behavior caused by dynamic recovery (DRV) and dynamic recrystallization (DRX) is conducive to the plastic deformation in the second stage rolling (low temperatures and high strain rates). In addition, the formation of mechanical twins further promotes DRX behavior. The softening mechanism of α2 phase is DRV, and that of γ phase is continuous dynamic recrystallization (CDRX) and discontinuous dynamic recrystallization (DDRX).

Keywords

• Powder metallurgy TiAl
• Hot-rolling
• Processing map
• Microstructure