Soils and Foundations (Dec 2023)
Primary and secondary consolidation characteristics of a high plasticity overconsolidated clay in compression and swelling
Abstract
For a reliable prediction of the time-development of soil deformations, a detailed characterization of both primary and secondary deformations is required. Nevertheless, in the current engineering practice the estimation of the primary and secondary deformations relies on the assumption of a constant coefficient of consolidation and a constant creep index respectively. However, high plasticity overconsolidated clays have reportedly complex stiffness and permeability relationships that challenge the validity of those assumptions. Analytical solutions of the one dimensional consolidation have been proposed, accounting for variation in permeability and oedometer modulus. Nevertheless, the methods assume a simplified log-linear and linear relationship with void ratio and effective stress for the two parameters, respectively. One-dimensional oedometer and constant rate of strain testing were employed to investigate the time-deformation development of a particular high plasticity overconsolidated clay. A dependency of the time until the end of primary deformations on the stress path was observed, with the majority of the unloading steps extending well beyond the 24 h typical duration of a load increment. It was revealed that the coefficient of consolidation generally increases during consolidation, and it may vary by more than one order of magnitude at the early stages of the consolidation process. This variation has been attributed to a transient effect noticed in the permeability, which has not been previously reported. The linear relationship between primary and secondary deformation indices was confirmed as an upper bound. In an effort to better characterize the time dependent behaviour a new index, the primary time deformation index, was defined as the slope at the inflection point of the time-curves. This parameter was found to be linearly related to the creep index, presenting thus a potential of better predictions of the duration and magnitude of consolidation deformations for the engineering practice.
