A Low Profile, Dual-band, Dual Polarized Antenna for Indoor/Outdoor Wearable Application

Kashif Nisar Paracha; Sharul Kamal Abdul Rahim; Ping Jack Soh; Muhammad Ramlee Kamarudin; Kim-Geok Tan; Yew Chiong Lo; Mohammad Tariqul Islam

doi:10.1109/ACCESS.2019.2894330

IEEE Access (Jan 2019)

A Low Profile, Dual-band, Dual Polarized Antenna for Indoor/Outdoor Wearable Application

Kashif Nisar Paracha,
Sharul Kamal Abdul Rahim,
Ping Jack Soh,
Muhammad Ramlee Kamarudin,
Kim-Geok Tan,
Yew Chiong Lo,
Mohammad Tariqul Islam

Affiliations

Kashif Nisar Paracha: ORCiD; Wireless Communication Centre, School of Electrical Engineering, Universiti Teknologi Malaysia, Skudai, Malaysia
Sharul Kamal Abdul Rahim: Wireless Communication Centre, School of Electrical Engineering, Universiti Teknologi Malaysia, Skudai, Malaysia
Ping Jack Soh: ORCiD; Advanced Communication Engineering CoE, School of Computer and Communication Engineering, Universiti Malaysia Perlis, Arau, Malaysia
Muhammad Ramlee Kamarudin: ORCiD; Centre for Electronic Warfare Information and Cyber, Cranfield Defence and Security, Cranfield University, Defence Academy of the United Kingdom, Shrivenham, U.K.
Kim-Geok Tan: Faculty of Engineering & Technology, Multimedia University, Melaka, Malaysia
Yew Chiong Lo: Faculty of Electrical Engineering, Multimedia University, Cyberjaya, Malaysia
Mohammad Tariqul Islam: ORCiD; Department of Electrical, Electronics and Systems Engineering, Universiti Kebangsaan Malaysia, Bangi, Malaysia

DOI: https://doi.org/10.1109/ACCESS.2019.2894330
Journal volume & issue: Vol. 7
pp. 33277 – 33288

Abstract

Read online

A planar, low-profile, dual-band and dual-polarized antenna on a semi-flex substrate is proposed in this paper. The antenna is fabricated on Rogers substrate with a thickness of 3.04 mm and sized at 70.4×76.14×3.11 mm3 (0.37λ0 ×0.40λ0×0.016λ0) only. The circular polarization property is enabled in the global navigation satellite system (GNSS) L1/E1 (lower) band by introducing a complementary split ring resonator on the antenna patch. Meanwhile, the antenna operates in the second (upper) 2.45 GHz WLAN band is enabled by etching a U-shaped slot on its ground plane. This simultaneous, dual-band and dual-polarized operation enables the proposed antenna to be applied in the indoor/outdoor wearable application. To isolate the antenna against the influence of the human body, a multiband artificial magnetic conductor (AMC) plane is added on the reverse side of the dual-band radiator. Comparison of the antenna without AMC in free space and when evaluated on the chest of a human body backed by AMC showed improved gain; from 3-5.1 dBi in the lower band, and from 1.53-5.03 dBi in the upper band. Besides that, the front-to-back ratio of the AMC backed monopole antenna also improved from 11-21.88 dB and from 2.5-24.5 dB in the GNSS and WLAN bands, respectively. Next, the specific absorption rate (SAR) of the monopole antenna with and without the AMC plane is assessed. Evaluation results indicate that the maximum SAR value decreased by up to 89.45 % in comparison with the antenna without AMC in the lower band. This indicates the effectiveness of the AMC array in increasing gain and FBR, besides reducing EM absorption in the human body.

Published in IEEE Access

ISSN: 2169-3536 (Online)
Publisher: IEEE
Country of publisher: United States
LCC subjects: Technology: Electrical engineering. Electronics. Nuclear engineering
Website: https://ieeexplore.ieee.org/xpl/RecentIssue.jsp?punumber=6287639

About the journal

Abstract

Keywords