Aging rate, environmental risk and production efficiency of the low-density polyethylene (LDPE) films with contrasting thickness in irrigated region

Abstract

Physical thickness of low-density polyethylene (LDPE) films might determine the release rate of phthalic acid esters (PAEs) & structural integrity and affect production efficiency. However, this critical issue is still unclear and little reported. Aging effects were evaluated in LDPE films with the thickness of 0.006, 0.008, 0.010 and 0.015 mm in a maize field of irrigation region. The Scanning electron microscope (SEM) results showed that the proportion of damaged area (Dam) to total area of LDPE films was massively lowered with increasing thickness after aging. The highest and lowest Dam was 32.2% and 3.5% in 0.006 and 0.015 mm films respectively. Also, the variations in peak intensity of asymmetric & symmetrical stretching vibrations (ASVI & SSVI) were detected using Fourier transform infrared spectrum (FTIR), indicating that the declines in peak intensity tended to be slower with thickness. Interestingly, the declines in physical integrity were tightly associated with increasing exhalation rate of PAEs. Average releasing rate of PAEs was 38.2%, 31.4%, 31.5% and 19.7% in LDPE films from 0.006 to 0.015 mm respectively. Critically, thicker film mulching can lead to greater soil water storage at plough layer (SWS-PL) and better thermal status, accordingly harvesting higher economic benefit. Therefore, LDPE film thickening may be a solution to reduce environmental risk but improve production efficiency in arid region.

Keywords

• LDPE film thickness
• Aging rate
• PAEs
• Water productivity
• Dryland maize