Evaluation of Spiral Pneumatic Rubber Actuator Using Finite Element Analysis for Radial Transportation

Abstract

Emerging actuators with various soft materials and a traveling wave motion are frequently discussed. Various configurations have been proposed and their resulting performances investigated, but it remains challenging to realize large strokes. This study presents an experimentally validated nonlinear finite element model to predict the deformation produced by a spiral pneumatic rubber actuator to generate a traveling wave motion. The actuator consists of a membrane mounted on a rubber substrate with three air chambers in a spiral configuration. The sequential deformations of the successive chambers interact with each other and produce radial traveling waves on the membrane surface, driving the objects placed on the actuator. Finite element analysis with ANSYS computer software was used to analyze the elastic movement by considering the influence of different initial structural types. The simulation results indicated an optimal structure with specific ratios. A reasonable correlation was obtained during experimental validation; the predicted displacement values were approximately 17% smaller than the experimental values. Finally, the transportation performance of the prototype was tested, and a velocity of 2.28 mm/s in the desired direction was achieved. We expect that our demonstration will expand the range of applications of the spiral pneumatic rubber actuator to include conveying or worm-like robots.

Keywords

• soft robotics
• soft pneumatic actuators
• traveling wave
• spiral structure
• finite element analysis