Influence of additive system (Al2O3-RE2O3 , RE = Y, La, Nd, Dy, Yb) on microstructure and mechanical properties of silicon nitride-based ceramics

Abstract

Silicon nitride based ceramics have been widely used as structural ceramics, due mainly to their thermo-mechanical properties such as high density, high thermal shock resistance, corrosion resistance and chemical stability. The aim of this study was to determine the influence of rare earth and aluminum oxide additions as sintering aids on densification, microstructure and mechanical properties of silicon nitride. Silicon nitride mixtures with 91 wt. (%) Si3N4 and 9% wt. (%) additives were prepared and sintered. The density, microstructure and mechanical properties of the sintered specimens of these mixtures were determined. In most specimens, scanning electron microscopic examination and X ray diffraction analysis revealed elongated grains of β-Si3N4 with aspect ratio of about 2.0 and dispersed in a glassy phase. The density of the sintered specimens was higher than 94% of the theoretical density (td) and specimens with La2O3 and Al2O3 additions exhibited the highest value. The results of this investigation indicate that the rare earth ion size influences densification of silicon nitride, but this correlation was not observed in specimens containing two different rare earth oxides. The hardness values varied in direct proportion to the density of the specimens and the fracture toughness values were influenced by the composition of the intergranular glassy phase.

Keywords

• silicon nitride
• sintering
• rare earth additives
• mechanical properties