Comparison of Prostate-Specific Antigen and Its Density and Prostate Health Index and Its Density for Detection of Prostate Cancer

Abstract

As the incidence of prostate cancer (PCa) has increased, screening based on prostate-specific antigen (PSA) has become controversial due to the low specificity of PSA. Therefore, we investigated the diagnostic performance of prostate health index (PHI) density (PHID) for the detection of PCa and clinically significant PCa (csPCa) compared to PSA, PSA density (PSAD), and PHI as a triaging test. We retrospectively reviewed 306 men who underwent prostate biopsy for PSA levels of 2.5 to 10 ng/mL between January 2020 and April 2023. Of all cohorts, 86 (28.1%) and 48 (15.7%) men were diagnosed with PCa and csPCa, respectively. In ROC analysis, the highest AUC was identified for PHID (0.812), followed by PHI (0.791), PSAD (0.650), and PSA (0.571) for PCa. A similar trend was observed for csPCa: PHID (AUC 0.826), PHI (AUC 0.796), PSAD (AUC 0.671), and PSA (0.552). When the biopsy was restricted to men with a PHID ≥ 0.56, 26.5% of unnecessary biopsies could be avoided; however, 9.3% of PCa cases and one csPCa case (2.1%) remained undiagnosed. At approximately 90% sensitivity for csPCa, at the given cut-off values of PHI ≥ 36.4, and PHID ≥ 0.91, 48.7% and 49.3% of unnecessary biopsies could be avoided. In conclusion, PHID had a small advantage over PHI, about 3.6%, for the reduction in unnecessary biopsies for PCa. The PHID and PHI showed almost the same diagnostic performance for csPCa detection. PHID can be used as a triaging test in a clinical setting to pre-select the risk of PCa and csPCa.

Keywords

• prostate cancer
• prostate-specific antigen
• prostate-specific antigen density
• prostate health index
• prostate health index density