The Influence of Luminaire Photometric Intensity Curve Measurements Quality on Road Lighting Design Parameters

Abstract

This article presents the research on a road lighting design. In this kind of design for a specific type of a roadway, the number and spacing of luminaires are calculated on the basis of luminaire photometric parameters such as intensity curve (LPIC) and luminous flux. The values of these parameters are measured using the luxmeter, i.e., a measuring instrument in which the spectral sensitivity should imitate spectral sensitivity of the human eye V(λ). However, the luxmeter’s spectral sensitivity S(λ) is not perfectly matched with the required one and varies for different instruments, resulting in measurement errors. To avoid this measurement error, the spectral mismatch correction factor (SMCF) should be applied to luxmeter’s readings. For a given luxmeter, the SMCF values depend on the measured light’s spectral composition SPD (described also by the lamp’s correlated color temperature CCT). Unfortunately, many laboratories do not apply SMCF to their luxmeter readings. Typical measurement laboratories are not in possession of SMCF data as this kind of data is hard to obtain and can be provided only by the state-of-the-art photometric laboratories for a high cost. Consequently, these typical measurement laboratories provide inaccurate LPIC data to costumers. In this article, it has been shown that a design process of road lighting installations needs to be based on lighting fixture LPIC’s measurements with SMCF values being taken into account. Omitting this fact may result in road lighting installation made on the basis of a design utilizing incorrect LPIC data, which would have higher energy consumption then expected at a design stage.

Keywords

• street lighting
• luminaire photometric intensity curve
• luxmeter
• energy efficiency