Theoretical Study of Asymmetric Bending Force on Metal Deformation in Cold Rolling

Abstract

A three-dimensional elastic–plastic finite element model of a six-roll cold rolling mill has been developed using the finite element software ABAQUS. The actual parameters of the rolling mill have been incorporated into the finite element model, with the working conditions applied as boundary constraints and load conditions. Subsequently, a non-symmetrical bending force is introduced to the finite element model. Through simulation calculations, this study analyzes the patterns of change in the transverse pressure of the rolling mill and roller pressure during non-symmetrical bending, as well as the variations in strip thickness, crown, edge drop, and flatness. Additionally, the regulating function of the bending force is examined. Each adjustment of 5 t in the asymmetric bending force results in an increase of approximately 0.01 mm in the thickness of the positive bending side of the strip while causing a decrease of about 0.01 mm in the thickness of the negative bending side. Therefore, the application of asymmetric bending forces proves to be effective in controlling the shape of lateral wave defects on the edges of steel strips.

Keywords

• asymmetrical bending force
• flatness
• strip
• finite element