Scientific Reports (Mar 2024)
Evolutionary law and regulatory technology of roof migration on gob-side entry retaining
Abstract
Abstract In order to study the evolutionary law of roof migration on Gob-Side Entry Retaining, this paper takes the gob-side entry retaining in the comprehensive mining face of the Ningtiaota coal mine as the engineering background, and analyzes the evolutionary law of the overlying rock layer on the roof at different locations during the roadway stay and the stress distribution around the roadway through numerical simulation software, which shows that there is a concentration of stress inside the Flexible formwork concrete wall, and therefore the maximum settlement of the roof on the side of Flexible formwork concrete wall is 35.35 mm, due to the existence of “arch-shaped” decompression area from the working face. Therefore, the maximum settlement of the roof slab on the side of flexible formwork concrete wall was 35.35 mm. Due to the existence of “arch-shaped” decompression area on the roof and floor of roadway, the settlement of the roof slab on both sides of the roadway gradually increased when it was from − 20 to 10 m away from the working face, and the central position had the following pattern of firstly decreasing and then gradually increasing, and then exceeding the top of the roadway. After decreasing and then gradually increasing, after 10 m ahead of the working face, the two sides of the roadway roof subsidence law and the central part of the roadway to maintain the same; the use of cutting the top of the flexible mold concrete wall support technology as a means of controlling the top of the roof along the empty roadway subsidence, the analysis shows that the roof after roof cutting of the amount of subsidence have been reduced, the maximum difference in the rate of change of the displacement is 0.011%, and the maximum difference in the amount of subsidence of 4.98 mm; through the field monitoring data analysis of the pressure of mining The peak value of the influence curve of the working face is located at 19 m of the working face, 9 m of the lagging working face and 19 m of the roadway outside the working face are less affected by the additional mining stress field, comparing the fracture brokenness of the roadway roof before and after the roof cutting, the fracture area in the uncut section is much larger than that in the section of the roof cutting.
Keywords
