Research on the New Drive of a Laboratory Screen with Rectilinear Vibrations in Transient States

Abstract

The paper presents the results of research on the vibrating motion of a laboratory screen with a rectilinear (segmental) trajectory of vibrations during its start-up and braking. The investigations were carried out on a modernized stand equipped with a system of two vibrating motors applied in newer solutions of industrial screens, which are mounted directly on the riddle. The tests were carried out for three different frequencies using three-axis acceleration sensors. The analysed parameter was the increase in the amplitude of vibrations in transient states compared to the amplitude during the stable operation of the device. The maximum multiplication of the vibration amplitude of the classic drive system during start-up was 9.7 (mm/mm) in the vertical direction and 5.7 (mm/mm) for the new system. During braking, the maximum multiplication of the vibration amplitude of the classic drive system was 6.9 (mm/mm) vertically, while for the drive system with vibration motors, it was 11.4 (mm/mm). The absence of flexible couplings in the drive system reduces the damping of vibrations and increases the value of amplitude during the start-up and free braking of the machine. This does not have a major influence on the correct operation of the machine in a steady state. However, the use of the new drive system resulted in a significant reduction in power demand and shortened the start-up time, which has a positive effect on the operating costs of the machine.

Keywords

• vibrating screen
• vibrating motor
• screen power demand
• vibrating screen modernization