Materials (Feb 2021)

A Comparative Analysis of Laser Additive Manufacturing of High Layer Thickness Pure Ti and Inconel 718 Alloy Materials Using Finite Element Method

  • Sapam Ningthemba Singh,
  • Sohini Chowdhury,
  • Yadaiah Nirsanametla,
  • Anil Kumar Deepati,
  • Chander Prakash,
  • Sunpreet Singh,
  • Linda Yongling Wu,
  • Hongyu Y. Zheng,
  • Catalin Pruncu

DOI
https://doi.org/10.3390/ma14040876
Journal volume & issue
Vol. 14, no. 4
p. 876

Abstract

Read online

Investigation of the selective laser melting (SLM) process, using finite element method, to understand the influences of laser power and scanning speed on the heat flow and melt-pool dimensions is a challenging task. Most of the existing studies are focused on the study of thin layer thickness and comparative study of same materials under different manufacturing conditions. The present work is focused on comparative analysis of thermal cycles and complex melt-pool behavior of a high layer thickness multi-layer laser additive manufacturing (LAM) of pure Titanium (Ti) and Inconel 718. A transient 3D finite-element model is developed to perform a quantitative comparative study on two materials to examine the temperature distribution and disparities in melt-pool behaviours under similar processing conditions. It is observed that the layers are properly melted and sintered for the considered process parameters. The temperature and melt-pool increases as laser power move in the same layer and when new layers are added. The same is observed when the laser power increases, and opposite is observed for increasing scanning speed while keeping other parameters constant. It is also found that Inconel 718 alloy has a higher maximum temperature than Ti material for the same process parameter and hence higher melt-pool dimensions.

Keywords