Effect of a Detached Bi-Partition on the Drag Reduction for Flow Past a Square Cylinder

Abstract

The objective of this research is to study the fluid flow control allowing the reduction of aerodynamic drag around a square cylinder using two parallel partitions placed downstream of the cylinder using the lattice Boltzmann method with multiple relaxation times (MRT-LBM). In contrast to several existing investigations in the literature that study either the effect of position or the effect of length of a single horizontal or vertical plate, this work presents a numerical study on the effect of Reynolds number (Re), horizontal position (g), vertical position (a), and length (Lp) of the two control partitions. Therefore, this work will be considered as an assembly of several results presented in a single work. Indeed, the Reynolds numbers are selected from 20 to 300, the gap spacing (0 ≤ g ≤ 13), the vertical positions (0 ≤ a ≤ 0.8d), and the lengths of partitions (1d ≤ Lp ≤ 5d). To identify the different changes appearing in the flow and forces, we have conducted in this study a detailed analysis of velocity contours, lift and drag coefficients, and the root-mean-square value of the lift coefficient. The obtained results revealed three different flow regimes as the gap spacing was varied. Namely, the extended body regime for 0 ≤ g ≤ 3.9, the attachment flow regime for 4 ≤ g ≤ 5.5, and the completely developed flow regime for 6 ≤ g ≤ 13. A maximal percentage reduction in drag coefficient equal to 12.5%, is given at the critical gap spacing (gcr = 3.9). Also, at the length of the critical partition (Lpcr = 3d), a Cd reduction percentage of 12.95% was found in comparison with the case without control. Moreover, the position of the optimal partition was found to be equal to 0.8d i.e. one is placed on the top edge of the square cylinder and the second one is placed on the bottom edge. The maximum value of the lift coefficient is reached for a plate length Lp = 2d when the plates are placed at a distance g = 4. On the other hand, this coefficient has almost the same mean value for all spacings between the two plates. Similarly, the root means the square value of the lift coefficient (Clrms) admits zero values for low Reynolds numbers and then increases slightly until it reaches its maximum for Re = 300.

Keywords

• lattice boltzmann method
• square cylinder
• double partition
• gap spacing
• vortex shedding
• flow control
• drag and lift coefficient.