Buildings (Oct 2022)
Bearing Behavior of Axially Compressed High-Strength Steel Columns in Precipitator Casing Considering the Stressed-Skin Effect of Wallboard
Abstract
To explore the application feasibility of high-strength steel in skeleton columns of precipitator casing structures, the bearing behavior of axially compressed H-section high-strength steel columns was investigated by the nonlinear finite element method by considering the stressed-skin effect of wallboard. When the column yield strength does not exceed 460 MPa, the column undergoes elasto-plastic interactive buckling, which means the steel strength can be fully utilized. For the column strength of 550 MPa or 690 MPa, the wallboard yield failure occurs, owing to excessive loading of the relatively weak wallboard, and column stress magnitude is usually in the elastic range without the full utilization of steel strength, whereas if the wallboard is stiff enough, columns will still undergo buckling failure. A welding residual stress measuring test was conducted to validate the residual stress generation simulation via the thermal-mechanical coupling finite element method. Concerning the geometrical imperfections and residual stresses, it was found that their influence becomes less severe when the column steel strength increases. The bearing capacity can be improved by increasing the wallboard thickness and stiffener stiffness, or reducing the wallboard width, the stiffener spacing, the width-to-thickness ratio of column flange, the height-to-thickness ratio of column web, and column torsional slenderness ratio. Column material can be fully utilized when column steel strength does not exceed 460 MPa. Hence, employing high-strength steel is reasonable. When the column steel strength is equal to or higher than 550 MPa, wallboard strength should be sufficient to ensure that the column failure occurs before wallboard failure. In such cases, high-strength steel should be used carefully.
Keywords
