Tribological Properties of Aluminium Matrix Syntactic Foams Manufactured with Aluminium Smelter Waste

Abstract

Aluminium smelter waste (ASW) is a big contributor to landfills, and its recycling has been of great interest. This study investigates the tribological properties of aluminium matrix syntactic foams manufactured using an Al 6082 alloy and ASW. Ball-on-disc tests were conducted under both dry and lubricated conditions. Under dry sliding conditions, the coefficient of friction (COF) had an initial sharp increase, followed by a gradual decrease and finally a steady state as the sliding distance increased. The wear surfaces showed the presence of adhesive, abrasive and oxidative wear, with some presence of delamination. Syntactic foams containing small ASW particles led to a decrease in surface roughness, decrease in the average COF and decrease in specific wear. Heating large ASW particles before manufacturing the syntactic foams enhanced overall wear properties because the particles are hardened due to a compositional change. The T6 treatment of the syntactic foams enhanced the wear properties due to the hardening of the Al matrix. The average COF of the ASW syntactic foams was higher than that of the E-sphere syntactic foam, which was predominantly abrasive wear. The specific wear of the ASW syntactic foams can be higher or lower than the E-sphere syntactic foam, depending on the ASW particle size. Under lubricated sliding test conditions, the wear was reduced significantly, and the type changed from predominantly adhesive to predominantly abrasive. The porous ASW particles acted as lubricant reservoirs and provided a constant supply of lubricant, further improving the lubrication effect.

Keywords

• syntactic foam
• smelter waste reuse
• friction
• wear