Cerâmica (Mar 2011)

Retificação de cerâmica de alumina relacionada com diferentes técnicas de lubri-refrigeração: convencional e mínima quantidade de lubrificação Grinding of alumina ceramics with different cooling and lubrification techniques: conventional and minimum quantity of lubrification

  • R. M. e Sousa,
  • D. M. Iceri,
  • R. S. Destro,
  • M. H. Oikawa,
  • E. C. Bianchi,
  • P. R. de Aguiar,
  • C. A. Fortulan

DOI
https://doi.org/10.1590/S0366-69132011000100010
Journal volume & issue
Vol. 57, no. 341
pp. 76 – 84

Abstract

Read online

Atualmente a preocupação ambiental está fazendo com que as empresas busquem diminuir os impactos ambientais por elas causados, ao mesmo tempo em que melhoram a qualidade do produto e processos de fabricação. Logo, muitas pesquisas estão sendo desenvolvidas na área de usinagem para se analisar o real dano ao meio ambiente quando usados diferentes métodos de lubri-refrigeração. Este trabalho teve como objetivo analisar a qualidade da peça produzida e o desgaste do ferramental de corte de uma retificadora plana ao se usinar cerâmica de alumina com dois métodos distintos de aplicação de fluido de corte: método convencional com vazão de 458,3 mL/h e o método da mínima quantidade de lubrificação (MQL) com 100 mL/h. A partir dos resultados obtidos pode-se constatar que para os mesmos parâmetros de usinagem a técnica do MQL utilizou uma quantidade muito menor de fluido e garantiu bons resultados de desgaste diametral do rebolo. No entanto, a qualidade da peça foi bem pior para o método do MQL em relação a técnica de refrigeração convencional. Estes resultados mostraram que se utilizando formas alternativas de lubrificação para reduzir o uso do fluido de corte, são possíveis dependendo de quais fatores são mais importantes para o processo que se deseja. Nesse sentido, se o método do MQL fosse adotado pelas empresas dependentes da retificação, certamente iria trazer, de um lado, benefícios quanto a problemas de descarte e reciclagem de fluido de corte, mas por outro lado, levaria a uma menor qualidade superficial das peças.Nowadays, environmental concerns are causing companies to seek reduce the environmental impacts caused by them, while improving product quality and manufacturing processes. Therefore, much research is being developed in the machining area to examine the actual damage to the environment by utilizing different methods of lubrification and cooling. This study aimed to analyze the surface roughness of the machined part and the wear of the grinding wheel in the flat grinding of alumina ceramics with two methods of cooling-lubrification: The conventional method with a flow rate of 27.5 L/min and the method of the minimum quantity of lubrification (MQL) at 100 mL/h. With the obtained results it's possible to say that, for the same machining parameters of MQL and conventional techniques, the MQL technique used a much smaller amount of fluid and assured good results for the diametral wear of the grinding wheel. However, the superficial roughness of the piece was worse for the MQL method than the conventional cooling technique. These results showed that using alternative forms of lubrification to reduce the use of cutting fluid are possible, depending on which factors are most important to the process that is wanted. Accordingly, if the MQL technique was used, it would surely bring, on one hand, the benefits of the reduction of the problems of recycling and disposal the cutting fluid, but on the other hand, leads to a lower surface quality of the parts.

Keywords