Powder Bed Selective Laser Processing of Alumina: Scanning Strategies Investigation

Abstract

Powder Bed Selective Laser Processing (PBSLP) is a promising technique for the additive manufacturing of alumina. For the method’s success, PBSLP process parameters such as laser power, scanning speed, hatching distance, and scanning strategies need to be investigated. This paper focuses on studying the scanning strategies’ effects on the PBSLP of alumina numerically and experimentally. Scanning strategies such as linear with different orientation, concentric, and islands were investigated. A numerical model was developed in which the PBSLP parameters, scanning strategy effects, and interpreting the experimental results could be observed. The numerical model proved its ability to reach the proper process parameters instead of using experimental trails which are time and cost consuming. For relative density, the island strategy succeeded to print alumina samples with a high relative density reaching 87.8%. However, there are round passages formed inside the samples that remain a barrier for the island strategy to be effectively used in PBSLP of alumina. Both linear and concentric strategies achieved a relative density of 75% and 67%, respectively. Considering the top surface roughness, samples printed with linear strategies gave low top surface roughness compared to the island and concentric strategies. Linear-45° is considered the effective strategy among the studied strategies as it achieved good relative density and low roughness at top and side surfaces. For PBSLP of alumina, new scanning strategies should be considered, and this study presents a new scanning strategy that is mainly based on space filling mathematical curves and should be studied in future work.

Keywords

• selective laser processing
• alumina
• simulation
• scanning strategy