Авіаційно-космічна техніка та технологія (Aug 2023)
Temperature characteristic of the electrical resistance of the strain gauge when measuring static and thermal stresses of parts at temperatures up to 700°С
Abstract
An overview of the existing methods of measuring static stresses at elevated temperatures, at which it is problematic to use classical strain gauges, and methods of compensating the imaginary temperature deformation was performed. Namely: the use of multi-component alloys, the manufacture of active and compensatory sensitive elements from different alloys, which should theoretically compensate for each other's shortcomings. In practice, this can be sufficiently achieved only in a narrow temperature range. The described primary transducer is a rectangular strain-gauge rosette for measuring static and thermal stresses in structural parts operating under extreme conditions at temperatures up to 700°C. This sensor is a two-layer rosette consisting of two sensitive elements (SE), the main axes of which are rotated relative to each other by 90°. The lower SE perceives the main deformation of the part, and the upper one, located above the lower one, plays the role of a temperature-compensating electrical resistance of the element and simultaneously registers the transverse deformation of the part. SE rosettes were made of a wire with a diameter of 30 microns of the Х20Н80 alloy and fixed to each other and to the part using Ц-165-32А cement. The experimental study consisted in determining the temperature characteristics of the resistance of both the lower and the upper SE of the studied strain gauge associated with the temperature expansion of the part-strain gauge system as well as with the shunting of the insulator-connector and the change in the specific resistance of the SE material. Experimental determination of apparent strain gauge deformation at different temperatures was performed. To determine the influence of the coefficient of linear expansion of the material of the part on the change in the resistance of the SE, strain gauges were attached to samples of various materials. The change in the apparent deformation of the strain gauge in the temperature range from room temperature to 700 °C is shown. Its maximum value for the ceramic sample was less than 350 µm/m, for the 30ХГСА steel sample it was less than 1000 µm/m, and for the ВЖЛ14Н-ВІ alloy sample it was less than 750 µm/m. Dependencies were obtained that allow corrections to be made in the result of a real study of the stressed state of the part to achieve the maximum accuracy of measurements.
Keywords
