Investigating the morphology, hardness, and porosity of copper filters produced via Hydraulic Pressing

Abstract

This paper presents an examination of the production of copper air filters via the Hydraulic Pressing (HP) method. Processing conditions examined included powder particle type (spherical and dendritic), varying compaction pressures (635, 714, and 793 MPa) and different pore forming (polyvinyl alcohol (PVA)) concentrations (1, 2, and 3 wt.%). Following compaction, the samples were thermally sintered in a two stage sintering regime at 200 °C and 750 °C. The morphology, porosity, and mechanical properties of the sintered samples were characterised. Morphological analysis demonstrated better consolidation and overlapping of the copper powder particles in samples with a higher weight percentage of the PVA. Highest porosity was achieved in the sample produced using the dendritic copper powder mixed with highest weight percentage of PVA. As the samples were very porous, the hardness of the samples varied greatly. Samples prepared with spherical powders at high pressure demonstrated the highest hardness. The results in this study show that copper filters with 14%–26% porosity can effectively be produced using spherical and dendritic copper powders by controlling the compaction pressure and PVA concentration.

Keywords

• Copper filters
• Powder compaction
• Microstructure
• Morphology analysis
• Porosity