Flexural behavior of steel fiber reinforced concrete beams comprising coarse and fine rubber and strengthened by CFRP sheets

Abstract

Despite having many advantages, using rubber to produce reinforced concrete members like beams is still restricted. When there is more waste tire rubber in concrete structures, rubber concrete's flexural and compressive strengths gradually decrease. However, this study used steel fibers to improve compressive strength and externally bonded carbon fiber-reinforced polymer (CFRP) sheets to increase flexural strength. Four groups of three reinforced concrete beams each were established for the study's use. The first and third groups of concrete beams used a volumetric replacement of fine and coarse aggregates with 5% and 10% waste tire rubber. However, steel fibers were added to the second and third groups at a rate of 1.25% of the concrete volume. Waste tire rubber and steel fibers were not replaced or added to the fourth group, the main reference group. The dimensions of each beam were 2.1×0.2×0.3 m. A concrete beam's first member is always free of external reinforcement, followed by its second member, which has one layer, and its third member, which has two layers of CFRP sheet. ABAQUS, a finite element analysis program, was used numerically to represent the third strengthening layer. The results showed that strengthening the reinforced rubberized concrete beams with a single layer of CFRP sheets increased the load at first crack and failure by 8.57% and 17.64%, respectively, compared to the unreinforced reference beam, compensating for the loss caused by the production of rubberized concrete and adding additional flexural strength. These loads increased by 31.43% and 26.45%, respectively, due to the steel fibers added to the beams containing these waste tire rubber. Strengthening with two layers of CFRP sheets increased the load at first crack and failure by 17.14 and 34.27, respectively. The steel fibers added to the beams that contained these amounts of waste tire rubber, on the other hand, caused these loads to increase by 42.86 and 49.23%, respectively. Strengthening with three layers numerically results in an exponential increase in load at the first crack and the failure by 8.03 and 52.88%, respectively. On the other hand, the loads on the beams that contained these quantities of waste tire rubber increased by 50.49% and 104.47%, respectively, when steel fibers were added to them.