Scientific Reports (Jul 2024)

Adsorptive removal of phosphate from water with biochar from acacia tree modified with iron and magnesium oxides

  • Yehia Manawi,
  • Rashad Al-Gaashani,
  • Simjo Simson,
  • Yongfeng Tong,
  • Jenny Lawler,
  • Viktor Kochkodan

DOI
https://doi.org/10.1038/s41598-024-66965-3
Journal volume & issue
Vol. 14, no. 1
pp. 1 – 20

Abstract

Read online

Abstract A novel biochar (BC) from Acacia tortilis trees pruning waste was synthesized and tested for the removal of phosphate from aqueous solutions. The BC was prepared by calcination at 600 °C and doped with Fe3O4 and MgO by hydrothermal process. The presence of iron and magnesium ions in the modified BC was confirmed by EDS analysis and X-ray diffraction (XRD) methods. Both unmodified and doped BCs were tested for phosphate removal from synthetic 1–500 ppm aqueous solutions. While the unmodified BC did not show any significant removal of phosphate from aqueous solutions, the modified BC almost completely removed phosphate from water. The enhancement in removal efficiency is due to an increase in the overall surface charge and surface area of BC as a result of doping with Fe3O4 and MgO salts. The average porosity and BET surface area corresponding to the plain BC increased by more than 20% from 322 to 394 m2/g after modification by impregnation with iron oxide and magnesium oxide. The modificaiton of BC with Fe3O4 and MgO nanoparticles was observed to increase the point of zero electric charge (PZC) from pH 3.4 (corresponding to plain BC) to pH 5.3 (corresponding to modified BC). The adsorption process was very fast and a phosphate removal value of 82.5% was reached only after 30 min of adsorption, while the removal efficiency after 4 h of adsorption was 97.5%. The rapid removal efficiency in short contact time is attributed to the high surface area of BC and strong bonding between the modified BC surface and PO4 3− ions. The highest adsorption capacity was observed to correspond to 98.5 mg/g which was achieved at PO4 3− concentration of 500 ppm and pH 8.5. Moreover, after fitting the adsorption data onto four of the most widely used adsorption isotherm models, the adsorption of PO4 3− onto BC can be better described by the Langmuir isotherm model.