5-nm LiF as an Efficient Cathode Buffer Layer in Polymer Solar Cells Through Simply Introducing a C60 Interlayer

Abstract

Abstract Lithium fluoride (LiF) is an efficient and widely used cathode buffer layer (CBL) in bulk heterojunction polymer solar cells (PSCs). The LiF thickness is normally limited to 1 nm due to its insulting property. Such small thickness is difficult to precise control during thermal deposition, and more importantly, 1-nm-thick LiF cannot provide sufficient protection for the underlying active layer. Herein, we demonstrated the application of a very thick LiF as CBL without sacrificing the device efficiency by simply inserting a C60 layer between the active layer and LiF layer. The devices with the C60/LiF (5 nm) double CBLs exhibit a peak power conversion efficiency (PCE) of 3.65%, which is twofold higher than that (1.79%) of LiF (5 nm)-only device. The superior performance of the C60/LiF (5 nm)-based devices is mainly attributed to the good electrical conductivity of the C60/LiF (5 nm) bilayer, arising from the intermixing occurred at the C60/LiF interface. Besides, the formation of a P3HT/C60 subcell and the optical spacer effect of C60 also contribute to the increase in short-circuit current density (J sc) of the device. With further increase of LiF thickness to 8 nm, a PCE of 1.10% is attained for the C60/LiF-based device, while the negligible photovoltaic performance is observed for the LiF-only device. All in all, our results show that C60/LiF bilayer is a promising alternative to LiF single layer due to its high tolerance to the LiF thickness variations.

Keywords

• Polymer solar cells
• Thick LiF buffer layer
• C60/LiF bilayer
• Mixed morphology