Gong-kuang zidonghua (Jun 2020)
Research on method of coal mine gas and coal dust explosion perception alarm and explosion source judgment
Abstract
Characteristics of coal mine gas and coal dust explosion are analyzed: Concentration of O2 in air decreases rapidly, while concentrations of CO2, CO and other toxic and harmful gases increase rapidly; Ambient temperature rises rapidly, and air pressure increases rapidly and then falls; Stronger infrared and ultraviolet radiation are generated; High-temperature, high-pressure, high-speed explosion shock wave and flame front are generated; Explosion sound and vibration are generated; A large amount of smoke and dust are generated; Wind speed increases rapidly and then falls, and wind flow reverses; Roadway collapses, electromechanical equipment is moved and damaged; A large number of casualties are caused. A coal mine gas and coal dust explosion perception alarm and explosion source judgment method based on multi-information fusion of gas (O2, CO2, CO)concentration, temperature, sound, vibration, air pressure, wind speed, wind direction, smoke, dust, infrared, ultraviolet and image is proposed: Gas and coal dust explosion can be identified through change of multi-parameters; Explosion source can be determined according to change range, change sequence of the parameters and sensor damage at different positions. Protection and setting methods of sensor are proposed: Sensor should be equipped with a streamlined or arc-shaped shell, and the sensor shell should use high-temperature resistant, fireproof and heat-insulating material; Sensor should be installed in center of roadway top; Sensor should be installed on mining face and heading face, and the sensor should be located 10-15 m away from the working face; Sensor should be installed in the middle of each roadway(without branches).Protection and setting methods of cable and optical cable are proposed: Armored cable and optical cable should be adopted, and the cable and optical cable should have properties of flame retardant, high-temperature resistance and impact resistance; Cable and optical cable should be buried at the angle between roadway side wall and floor; Cable and optical cable can also be protected by introducing into compressed air duct.
Keywords
