Analysis of the tensile strength of 3D printed elements

Donatas Medišauskas; Sergėjus Rimovskis; Artūras Sabaliauskas

doi:10.56131/tmt.2024.3.1.252

Taikomieji Moksliniai Tyrimai (May 2024)

Analysis of the tensile strength of 3D printed elements

Donatas Medišauskas,
Sergėjus Rimovskis,
Artūras Sabaliauskas

Affiliations

Donatas Medišauskas: Armament and equipment repair depot of the Air Force of the Lithuanian Armed Forces
Sergėjus Rimovskis: Šiaulių valstybinė kolegija / Higher Education Institution, Lithuania; Associate Professor at the Department of Transport Engineering, Doctor of Technological Sciences
Artūras Sabaliauskas: Šiaulių valstybinė kolegija / Higher Education Institution, Lithuania; Head of the Department of Transport Engineering, Associate Professor, Doctor of Technological Sciences

DOI: https://doi.org/10.56131/tmt.2024.3.1.252
Journal volume & issue: Vol. 3, no. 1
pp. 126 – 131

Abstract

Read online

The paper presents investigations of the mechanical properties of PLA plastic samples produced by a 3D printer under tension. The dependence of the maximum load on the selected 3D printing parameters (infill patterns and infill percentage) is compared. Octet, Zig Zag, Triangles and Grid infill pattern and infill percentage 50% and 90% are used.

Published in Taikomieji Moksliniai Tyrimai

ISSN: 2783-6290 (Online)
Publisher: Šiaulių valstybinė kolegija / Šiauliai State Higher Education Institution
Country of publisher: Lithuania
LCC subjects: Social Sciences; Medicine
Website: https://ojs.svako.lt/TMT

About the journal

Abstract

Keywords