Ain Shams Engineering Journal (Jun 2022)
BONMIN solver-based coordination of distributed FACTS compensators and distributed generation units in modern distribution networks
Abstract
The problems of increasing electricity consumption and atmospheric pollutants emissions are targeted as critical challenges for power transfer in modern distribution networks. In order to tackle this issue, many researchers have proposed the incorporation of Distributed Generator (DG) units, as well as different types of reactive power compensation devices, which will contribute to the increase of networks efficiency through loss minimization, voltage profile improvement, or even increasing transmission line’s capacity. This paper addresses the optimal allocation/coordination of DG, Distributed Static VAR Compensator (D-SVC), and Distributed Thyristor-Controlled Series Compensator (D-TCSC) to reduce total power loss in the distribution network. The allocation problem is formulated as a mixed-integer nonlinear programming (MINLP) and is solved using a basic open-source MINLP (BONMIN) solver embedded in GAMS. The proposed method was tested in IEEE 16-bus and 33-bus distribution test systems, where two cases were considered. Firstly, BONMIN solver is used for allocation of D-SVC, and D-TCSC, respectively, where the results showed that incorporation of these devices leads to reduction of the active power losses, while the minimal losses and highest efficiency increase for both test networks occurred in the case where 3 D-TCSCs allocated. Secondly, a coordinated allocation of DGs and D-SVCs, as well as DGs and D-TCSCs, is presented, where it was shown that coordination of these devices leads to even greater loss reduction, i.e. increased efficiency. Also, it was concluded that DG and D-TCSC coordination is better suited for loss reduction in the 16-bus system, while DG and D-SVC coordination leads to greater loss reduction for the 33-bus system. Furthermore, the comparison between BONMIN and metaheuristic methods was performed for DG allocation and DG and D-TCSC coordination in IEEE 33-bus system, where it was concluded that BONMIN performs better in terms of minimal power loss, compared to the results which were presented in the available literature. Finally, the BONMIN solver’s performance is evaluated using three parameters: number of nodes, number of iterations, and total execution time, where the numerical analysis showed that BONMIN is efficient in solving the addressed problems.
