A 3-D Metal-Printed Dual-Polarized Ridged Waveguide Slot Array Antenna for X-Band Applications

Abstract

A compact three-dimensional (3-D) metal-printed ridged waveguide slot array antenna with wideband, dual linear polarization and low cross-polarization is presented for X-band applications. The proposed design achieves a compact structure due to the method of using a ridged waveguide (RWG). A vertically linear polarized (VP) array is realized through eight longitudinal shunt slots etched on the non-ridged broad wall of the RWG, while a horizontally linear polarized (HP) array is realized through eight V-shaped slots cut on the ridged broad wall of the RWG. To extend the operating bandwidth, each 1 × 8-element linear array is separated into two 1 × 4-element sub-arrays through a central feeding technique. The two sub-arrays of the VP array are excited with equal amplitude and are 180° out-of-phase through a T-junction power divider, which connects the coaxial feed and the radiated waveguide, while the two HP subarrays are directly excited by a coaxial feed with equal amplitude and remain in phase. The feed structure uses coaxial probes directly attached to the RWG to provide good mechanical stability and low voltage around the feed. An optimized 2 × 8-element dual-polarized array is fabricated using 3-D metal-printing technology for experimental verification. The measured −10 dB impedance bandwidth of the VP array is 1.2 GHz (12.2%) and, of the HP array, is 1.1 GHz (11.2%) with maximum gains of 14.6 and 15.5 dBi, respectively. There is good polarization purity over the entire operating bandwidth with a cross-polarization level better than −40 dB in the main beam direction. The isolation between two orthogonal polarized arrays is greater than 40 dB over the whole band.

Keywords

• 3-D metal-printed
• wideband slot array antenna
• ridged waveguide
• dual-polarized
• low cross-polarization