Improving Data Quality for the Australian High Frequency Ocean Radar Network through Real-Time and Delayed-Mode Quality-Control Procedures

Abstract

Quality-control procedures and their impact on data quality are described for the High-Frequency Ocean Radar (HFR) network in Australia, in particular for the commercial phased-array (WERA) HFR type. Threshold-based quality-control procedures were used to obtain radial velocity and signal-to-noise ratio (SNR), however, values were set through quantitative analyses with independent measurements available within the HFR coverage, when available, or from long-term data statistics. An artifact removal procedure was also applied to the spatial distribution of SNR for the first-order Bragg peaks, under the assumption the SNR is a valid proxy for radial velocity quality and that SNR decays with range from the receiver. The proposed iterative procedure was specially designed to remove anomalous observations associated with strong SNR peaks caused by the 50 Hz sources. The procedure iteratively fits a polynomial along the radial beam (1-D case) or a surface (2-D case) to the SNR associated with the radial velocity. Observations that exceed a detection threshold were then identified and flagged. After removing suspect data, new iterations were run with updated detection thresholds until no additional spikes were found or a maximum number of iterations was reached.

Keywords

• HF ocean radar systems
• quality control
• remote-sensing