Frontiers in Mechanical Engineering (May 2022)
Integration and Encapsulation of Light-Emitting Diode and CMOS-MEMS Chips for Fluorescence Quenching Gas Sensor
Abstract
Environmental sensing units such as gas sensors, humidity sensors, pressure sensors, PM 2.5 sensors, or temperature sensors are widely used in our daily lives. In this study, CMOS-MEMS technology is exploited to fabricate and monolithically integrate the photo-sensors, temperature sensor, and mechanical structures for an optical gas sensing chip. An LED is bonded (heterogeneous integration) on the CMOS-MEMS chip as an excitation light source, and fluorescence quenching technology is employed for the presented optical gas sensor. Finally, the light emitted from the LED is reflected and redirected onto the CMOS-MEMS chip by using an encapsulated optical reflector to increase the sensitivity and reduce the power consumption for the presented sensor. In applications, the sensing materials are, respectively, mixed with C30H24Cl2N6Ru·6H2O and C16H7Na3O10S3 for O2 and CO2 detection. Moreover, the Si-based (by micromachining) and polymer-based (by 3D printing) optical reflectors are used to encapsulate the sensing chip to demonstrate the presented concept. Measurements show that the LED driving currents for gas sensors with reflectors are significantly reduced. Measurements also indicate that the sensitivities of gas sensors for sensing chips without optical reflectors are, respectively, 0.023 μA/% (O2/N2) and 0.12 μA/% (CO2/N2); for sensing chips with hemispherical shell optical reflectors are, respectively, 0.12 μA/% (O2/N2) and 0.19 μA/% (CO2/N2); and for sensing chips with flat plate optical reflectors are, respectively, 0.24 μA/% (O2/N2) and 0.32 μA/% (CO2/N2). The sensitivity of the temperature sensor is 0.07%/°C.
Keywords
