Effect of pH on the Mechanical Properties of Single-Biopolymer Mucilage (<i>Opuntia ficus-indica</i>), Pectin and Alginate Films: Development and Mechanical Characterisation

Abstract

Pectin and alginate are well-established biopolymers used in natural film development. Single-polymer mucilage films were developed from freeze-dried native mucilage powder of two cultivars, ‘Algerian’ and ‘Morado’, and the films’ mechanical properties were compared to single-polymer pectin and alginate films developed from commercially available pectin and alginate powders. The casting method prepared films forming solutions at 2.5%, 5%, and 7.5% (w/w) for each polymer. Considerable variations were observed in the films’ strength and elasticity between the various films at different polymer concentrations. Although mucilage films could be produced at 5% (w/w), both cultivars could not produce films with a tensile strength (TS) greater than 1 MPa. Mucilage films, however, displayed > 20% elongation at break (%E) values, being noticeably more elastic than the pectin and alginate films. The mechanical properties of the various films were further modified by varying the pH of the film-forming solution. The various films showed increased TS and puncture force (PF) values, although these increases were more noticeable for pectin and alginate than mucilage films. Although single-polymer mucilage films exhibit the potential to be used in developing natural packaging, pectin and alginate films possess more suitable mechanical attributes.

Keywords

• packaging
• cactus pear mucilage
• <i>Opuntia ficus-indica</i>
• pectin
• alginate
• biopolymer films