Salar de Atacama Lithium and Potassium Productive Process
David Torres,
Kevin Pérez,
Felipe M. Galleguillos Madrid,
Williams H. Leiva,
Edelmira Gálvez,
Eleazar Salinas-Rodríguez,
Sandra Gallegos,
Ingrid Jamett,
Jonathan Castillo,
Manuel Saldana,
Norman Toro
Affiliations
David Torres
Faculty of Engineering and Architecture, Universidad Arturo Prat, Iquique 1110939, Chile
Kevin Pérez
Faculty of Engineering and Architecture, Universidad Arturo Prat, Iquique 1110939, Chile
Felipe M. Galleguillos Madrid
Centro de Desarrollo Energético Antofagasta, Universidad de Antofagasta, Antofagasta 1240000, Chile
Williams H. Leiva
Facultad de Ingeniería, Arquitectura y Diseño, Universidad San Sebastián, Concepción 4030000, Chile
Edelmira Gálvez
Departamento de Ingeniería Metalúrgica y Minas, Universidad Católica del Norte, Antofagasta 1270709, Chile
Eleazar Salinas-Rodríguez
Academic Area of Earth Sciences and Materials, Institute of Basic Sciences and Engineering, Autonomous University of the State of Hidalgo, Pachuca 42184, Mexico
Sandra Gallegos
Faculty of Engineering and Architecture, Universidad Arturo Prat, Iquique 1110939, Chile
Ingrid Jamett
Centro de Economía Circular en Procesos Industriales (CECPI), Facultad de Ingeniería, Universidad de Antofagasta, Antofagasta 1270300, Chile
Jonathan Castillo
Departamento de Ingeniería en Metalurgia, Universidad de Atacama, Copiapó 1531772, Chile
Manuel Saldana
Faculty of Engineering and Architecture, Universidad Arturo Prat, Iquique 1110939, Chile
Norman Toro
Faculty of Engineering and Architecture, Universidad Arturo Prat, Iquique 1110939, Chile
The average lithium content in the Earth’s crust is estimated at about 0.007%. Despite this, lithium is considered abundant and widely distributed, with significant extraction from various sources. Notably, the brines in the Salar de Atacama are highlighted for their high lithium concentration ~1800 mg/L. Lithium is currently recovered from these brines through a solar evaporation process. The brine is transferred through a series of ponds, increasing the lithium concentration from 0.2% to 6% over 18 months, while decanting other minerals like potassium, magnesium, and boron. This method is the most efficient and cost-effective globally due to the Salar de Atacama’s high lithium concentration of approximately 1800 ppm and the region’s intense solar radiation, which facilitates evaporation at no economic cost. This manuscript describes in detail the lithium and potassium extraction processes used in the Salar de Atacama.