Investigation and impact assessment of soybean biodiesel, methyl oleate, and diesel blends on CRDI performance and emissions

Abstract

In the present study, a binary biofuel blend was prepared by blending soy methyl ester (SME100) and methyl oleate (MO) SME50-M50 with diesel. The physiochemical properties of blended fuels were also investigated. The performance and emissions characteristics of all fuel blends were estimated using a common-rail direct injection (CRDI) engine. The outcomes demonstrate a reduction in brake-specific fuel consumption (BSFC) when enriched biodiesel is used in comparison to SME100, nonetheless by the virtue of viscosity and heating value there is an increase in the BSFC value when compared to diesel. The average BSFC values were obtained as 5.3% (E25), 10.6% (E50), 17.5% (E75), 30% (SME100) and 14.9% (SME50-M50) higher than that of diesel. BTE was found to be highest for E25 and lowest for SME100 among all the blends. NOx emissions with blended biodiesel were slightly higher than diesel on account of MO being unsaturated, resulting in shorter ignition delay. The average NOx values obtained were higher than that of diesel and the corresponding values are 2.91% (E25), 4.1% (E50), 5.8% (E75), 8.3% (SME100) and 15.8% (SME50-M50). As a result of the increased oxygen content of the fuel, the concentrations of UHC and CO depreciated with the rise in concentration of soy methyl ester and MO (SME50-M50). Currently, Euro 6.2, which is the most recent emission regulation, uses 10% biofuel (B10); however, the results of this study establishes that E25, as an alternate fuel, complies with the contemporary engines without requiring any engine modifications.

Keywords

• Methyl oleate
• Enriched biodiesel
• Spectroscopic
• Exhaust emission engine performance