Design of Frequency-Selective Rasorbers Based on Centrosymmetric Bended-Strip Resonator

Min Guo; Zhanshan Sun; Di Sang; Xueqing Jia; Yunqi Fu

doi:10.1109/ACCESS.2019.2893347

IEEE Access (Jan 2019)

Design of Frequency-Selective Rasorbers Based on Centrosymmetric Bended-Strip Resonator

Min Guo,
Zhanshan Sun,
Di Sang,
Xueqing Jia,
Yunqi Fu

Affiliations

Min Guo: ORCiD; College of Electronic Science, National University of Defense Technology, Changsha, China
Zhanshan Sun: ORCiD; College of Electronic Science, National University of Defense Technology, Changsha, China
Di Sang: College of Electronic Science, National University of Defense Technology, Changsha, China
Xueqing Jia: College of Electronic Science, National University of Defense Technology, Changsha, China
Yunqi Fu: College of Electronic Science, National University of Defense Technology, Changsha, China

DOI: https://doi.org/10.1109/ACCESS.2019.2893347
Journal volume & issue: Vol. 7
pp. 24964 – 24970

Abstract

Read online

Two frequency-selective rasorber (FSR) structures using novel centrosymmetric bended-strip resonator (CBSR) are proposed in this paper. Both FSRs consist of the resistive sheet layer and the bandpass FSS layer with an air gap in the middle. The resistive sheet layer is constructed by inserting the CBSR into the center of the resistor-loaded dipole. The CBSR resonates at the transmission band of the bandpass FSS and exhibits infinite impedance, which is used to realize high-transmittance performance at the transmission band. The full wave simulation results show that the transmission band of one FSR is above the absorption band (A-T FSR), while the transmission band of another FSR is below the absorption band (T-A FSR). The transmission band of the A-T FSR and T-A FSR are separately located at 12.76 and 6.08 GHz with 0.66- and 0.13-dB insertion loss, and the corresponding absorption bands with absorption rate >90% are located at 6.10-10.98 GHz and 9.04-15.94 GHz, respectively. The CBSR used in T-A FSR (M-CBSR) is a miniaturized design of the CBSR used in A-T FSR. Comparing with the CBSR structure, the electric length of the M-CBSR's longer side is reduced to about 50%, which is only 12.2% of the wavelength of the transmission band. Two prototypes are fabricated and measured to verify the absorption/transmission performance of the proposed FSRs. The measured results are in good agreements with simulated results, which evidently demonstrates the validity of the proposed design.

Published in IEEE Access

ISSN: 2169-3536 (Online)
Publisher: IEEE
Country of publisher: United States
LCC subjects: Technology: Electrical engineering. Electronics. Nuclear engineering
Website: https://ieeexplore.ieee.org/xpl/RecentIssue.jsp?punumber=6287639

About the journal

Abstract

Keywords