Conversion of data from the laser scanner to the Ansys Workbench

Štalmach Ondrej; Sapietová Alžbeta; Dekýš Vladimír; Šulka Peter; Gajdoš Lukáš

doi:10.1051/matecconf/201925402003

MATEC Web of Conferences (Jan 2019)

Conversion of data from the laser scanner to the Ansys Workbench

Štalmach Ondrej,
Sapietová Alžbeta,
Dekýš Vladimír,
Šulka Peter,
Gajdoš Lukáš

Affiliations

Štalmach Ondrej: Department of Applied Mechanics, Faculty of mechanical engineering, University of Žilina
Sapietová Alžbeta: Department of Applied Mechanics, Faculty of mechanical engineering, University of Žilina
Dekýš Vladimír: Department of Applied Mechanics, Faculty of mechanical engineering, University of Žilina
Šulka Peter: Department of Applied Mechanics, Faculty of mechanical engineering, University of Žilina
Gajdoš Lukáš: Schaffler Slovakia

DOI: https://doi.org/10.1051/matecconf/201925402003
Journal volume & issue: Vol. 254
p. 02003

Abstract

Read online

This paper deals with the data processing in the form of a cloud of points scanned using a handheld 3D laser scanner. The aim of this paper is to use this data to create a representative FEM model and compare two different approaches while one of them involves creating a CAD model and the other one not. The data processing is carried out in the freeware systems MeshLab and Meshmixer and FEM analysis in the software ANSYS Workbench.

Published in MATEC Web of Conferences

ISSN: 2261-236X (Online)
Publisher: EDP Sciences
Country of publisher: France
LCC subjects: Technology: Engineering (General). Civil engineering (General)
Website: http://www.matec-conferences.org

About the journal

Abstract

Keywords