Virtual parameter calibration of pod pepper seeds based on discrete element simulation

Abstract

In order to achieve numerical optimization of the pod pepper seed sowing device, the contact parameters of pod pepper seeds were calibrated, with the angle of repose used as the response value. A set of discrete element method (DEM) models of pod pepper seeds was developed to simulate the formation of seed repose angles using reverse engineering reconstruction techniques. An eight-factor, three-level response surface experiment based on the Box-Behnken central combination test method was performed to study the effects of various factors on the angle of repose of seeds. The angle of repose obtained from physical experiments with a value of 27.56° was taken as the target value. The optimal combination of parameters is obtained as follows: seed Poisson's ratio of 0.22, seed shear modulus of 15.47 MPa, seed-to-seed static friction coefficient of 0.25, seed-to-seed rolling friction coefficient of 0.67, seed-to-seed collision recovery coefficient of 0.64, seed-to-steel-plate static friction coefficient of 0.55, seed-to-steel-plate rolling friction coefficient of 0.45, and seed-to-steel plate collision recovery coefficient of 0.34. A two-sample t-test of the angle of repose obtained by the cylinder lifting method and the pumping plate method against the target value yielded P > 0.05, indicating the reliability of the simulation experiments.

Keywords

• Pod pepper seeds
• Discrete element method
• Angle of repose
• Response surface methodology
• Contact parameter