Evaluation of saline and magnetized water on emitter hydraulic performance and clogging in drip irrigation

Abstract

Abstract The present investigation was carried out at the National Irrigation Laboratory of Agricultural Engineering Research Institute (AEnRI), Dokki, Giza, Egypt. This study was performed to investigate the hydraulic performance and clogging ratio of drip irrigation with magnetized water. Magnetized water was created by transferring water through a permanent magnet connected to a feed pipeline. Two main treatments of magnetized and non-magnetized water, as well as three sub-treatments of irrigation water salts, including fresh water (219 ppm) and the addition of 1000 and 2000 ppm to irrigation water with three replications were applied under different operating pressure (75, 100, 125 and 150 kPa). At the beginning of the experiment, results show that hydraulic parameters were almost the same for both the magnetized and the non-magnetized water and for all salinity levels. At the end of working time, the hydraulic parameters were improved for the magnetized water under salinity levels compared to the non-magnetized water. Average emitter discharge increased with roughly 2.7% and 5.6%, coefficient of variation (Cv) decreased by 0.6 and 0.91%, emission uniformity (Eu) increased about 1 and 1.1% and variation of average flow rate (qavr) decreased by 21.3 and 29.4% when 1000 and 2000 ppm were used, respectively. Magnetized water had slight effect on clogging at non-saline water at the end of experiment. At 1000 and 2000 ppm salinity levels, the clogging ratio decreased by 1.97 and 2.45% at different pressure, respectively. The results show that magnetized water treatment could effectively relieve and delay the occurrence time of clogging.

Keywords

• Magnetization
• Salinity
• Hydraulic parameters
• Drip irrigation