Development of Flexible and Partly Water-Soluble Binder Systems for Metal Fused Filament Fabrication (MF³) of Ti-6Al-4V Parts

Abstract

Metal Fused Filament Fabrication provides a simple and cost-efficient way to produce dense metal parts with a homogenous microstructure. However, current limitations include the use of hazardous and expensive organic solvents during debinding for flexible filaments the stiffness of filaments made from partly water-soluble binder systems. In this study, the influence of various additives on different partly water-soluble binder systems, with regard to the flexibility and properties of the final parts, was investigated. Furthermore, a method using dynamic mechanical analysis to quantify the flexibility of filaments was introduced and successfully applied. For the first time, it was possible to produce flexible, partly water-soluble filaments with 60 vol.% solid content, which allowed the 3D printing of complex small and large parts with a high level of detail. After sintering, density values of up to 98.9% of theoretical density were achieved, which is significantly higher than those obtained with existing binder systems.

Keywords

• 3D printing
• additive manufacturing
• FFF
• FDM
• MF³
• MEX