Results in Engineering (Jun 2024)
Investigation of a power factor correction converter utilizing SEPIC topology with input current switching
Abstract
The single-ended primary-inductor converter (SEPIC) is a popular converter topology that can be employed in diverse application fields where the needed output voltage is greater or lesser than the input voltage. The non-inverted output voltage of a SEPIC converter provides additional advantages when compared to a buck-boost or Ćuk converter. Furthermore, the position of the capacitor in the SEPIC converter provides inherent isolation and circuit safety. One drawback in the conventional bridge-diode SEPIC AC-DC converter is the lack of controllability which can be overcome by adding extra active switch(es) or by replacing the passive diode(s) with active switch(es). However, introducing more active switches increases the control complexity and may increase the requirement for additional driver circuits. To address this trade-off, this article proposes a single-phase AC to DC modified SEPIC converter with input current-switching capability without adding any extra active switch(es). The existing active switch of the DC-DC SEPIC converter was shifted towards the input side and thus no additional switch has been introduced. This allows the option of input-current switching without any additional complexity in the control or driver circuit. The circuit topology, principles of operation, and ideal voltage gain equations for the suggested circuit have been derived and included in this research work. The proposed circuit has been simulated in both open-loop conditions and closed-loop control with varying duty cycles and output load. Results from the simulation show that the proposed converter provides better efficiency (∼90 %) and lower total harmonic distortion (THD) (10 %) for varying duty cycles when compared to a conventional converter. The converter also shows good dynamic response. A low-power 15V hardware prototype has been built to experimentally validate the performance of the proposed converter. Experimental results illustrate that the suggested converter can improve the power factor by up to 0.968 while operating at an efficiency above 75 %. This converter topology can be suitable for applications where high output voltage gain, high power factor, and lower THD are needed without isolation requirements.
