Investigation on the thermal deformation mechanisms and constitutive model of Ti-55511 titanium alloy

Abstract

This study presents a comprehensive analysis of the hot deformation behavior of the Ti-55511 alloy over a temperature range of 700 °C–950 °C and strain rates from 0.001 s⁻1 to 1 s⁻1, utilizing isothermal compression testing alongside electron backscatter diffraction (EBSD) and transmission electron microscopy (TEM). The investigation focuses on the influence of various hot deformation parameters on the microstructural evolution of distinct phase regions within the alloy. At higher strain rates (0.1 s⁻1 to 1 s⁻1), the primary softening mechanisms for β grains in the α+β two-phase region are identified as continuous dynamic recrystallization (CDRX) and dynamic recovery (DRV), while in the β single-phase region, discontinuous dynamic recrystallization (DDRX) and DRV predominate. Conversely, at lower strain rates (0.001 s⁻1 to 0.01 s⁻1), the softening of β grains in the two-phase region is primarily governed by DRV, whereas in the single-phase region, DDRX and CDRX are the dominant mechanisms. Additionally, based on stress-strain data corrected for friction and temperature effects, an elastoplastic constitutive model is developed, incorporating strain rate and temperature to predict peak stress in the two-phase regions of the Ti-55511 alloy. This examination of the thermal deformation behavior and microstructural evolution of the Ti-55511 alloy provides significant theoretical and practical insights for optimizing the manufacturing processes of aviation die forging, tailoring microstructures, and enhancing hot working techniques.

Keywords

• Thermal deformation
• Dynamic recrystallization
• Constitutive model
• Ti-55511 titanium alloy