Dislocation response of ECC-RC composite supporting structures of tunnels passing through active fault

Abstract

Abstract To address the problems of the conventional composite supporting structures (CCSSs) such as insufficient anti-dislocation performance and deformation capacity, this study used Engineered Cementitious Composite (ECC) lining sections instead of the traditional lining sections and optimized support design parameters, resulting in the development of novel ECC-RC composite supporting structures (ECSSs) of tunnels passing through active fault. The dislocation response characteristics and their parameter sensitivity of the ECSS was revealed by way of 1/25-scale fault dislocation model tests and finite element analysis. The test results show that the mechanical response characteristics and the failure modes of the CCSS and the ECSS are similar under reverse fault dislocation. Compared with the CCSS, the anti-dislocation performance of the ECSS is significantly improved by introducing of the ECC lining and optimizing the design parameters. The vertical deformation of the ECSS and the range of influence under the same dislocation are significantly decreased, and the strain are reduced to different degrees. This phenomenon shows that by improving the material properties, shortening the spacing of aseismatic joints and optimising the thickness of the shock absorption layer, the stress conditions and applicability under deformation of the structure are improved. The ECSS benefits from the crack resistance and toughening effect of fibres, the degree and scope of cracking of the ECSS are significantly reduced compared with those of the CCSS, and internal and external through cracks and local spalling are absent. The results of finite element analysis show that the overall damage degree of the ECSS is decreased and the damage range is increased by decreasing the strength of the surrounding rock in the fault zone. The fault dislocation response pattern of the ECSS varies depending on the fault type. The damage degree caused by different fault types follows the order of normal fault, strike-slip fault, and reverse fault from large to small. However, the damage range caused by the strike-slip fault is significantly larger compared to normal fault and reverse fault. In the design of fault resistance, the surrounding rock conditions of the fault zone and the form of fault dislocation should be considered.

Keywords

• Engineered cementitious composite (ECC)
• Composite supporting structure
• Fault dislocation response
• Model tests
• Finite element analysis