Interfacial Deposition of Titanium Dioxide at the Polarized Liquid–Liquid Interface

Abstract

The interfacial polycondensation of titanium dioxide was studied at the bare and fiberglass membrane supported polarized liquid–liquid interface (LLI). Titanium dioxide synthesis was derived from the titanium (IV) tetrabutoxide (initially dissolved in the 1,2-dichloroethane) interfacial hydrolysis followed by its condensation. Experimental parameters, such as the pH of the aqueous phase and the influence of titanium alkoxide concentration in the organic phase on the electrochemical signal and material morphology, were investigated. The latter was achieved with fiberglass membranes used as the LLI support during TiO2 interfacial deposition. Cyclic voltammetry was used for the in situ studies, whereas scanning electron microscopy, energy-dispersive X-ray spectroscopy, and infrared spectroscopy were used during ex situ examination. The interfacial polycondensation reaction could be studied using electrified LLI and resulted in the material being a TiO2 film alone or film decorated with particles.

Keywords

• ITIES
• interfacial polycondensation
• electrochemistry
• voltammetry
• interfacial modification
• titanium dioxide synthesis