Crosslinked Gel Polymer Electrolyte from Trimethylolpropane Triglycidyl Ether by In Situ Polymerization for Lithium-Ion Batteries

Abstract

Electrolytes play a critical role in battery performance. They are associated with an increased risk of safety issues. The main challenge faced by many researchers is how to balance the physical and electrical properties of electrolytes. Gel polymer electrolytes (GPEs) have received increasing attention due to their satisfactory properties of ionic conductivity, mechanical stability, and safety. Herein, we develop a gel network polymer electrolyte (GNPE) to address the challenge mentioned earlier. This GNPE was formed by tri-epoxide monomer and bis(fluorosulfonyl)imide lithium salt (LiFSI) via an in situ cationic polymerization under mild thermal conditions. The obtained GNPE exhibited a relatively high ionic conductivity (σ) of 2.63 × 10−4 S cm−1, lithium transference number (tLi+, 0.58) at room temperature (RT), and intimate electrode compatibility with LiFePO4 and graphite. The LiFePO4/GNPE/graphite battery also showed a promising cyclic performance at RT, e.g., a suitable discharge specific capacity of 127 mAh g−1 and a high Coulombic efficiency (>97%) after 100 cycles at 0.2 C. Moreover, electrolyte films showed good mechanical stability and formed the SEI layer on the graphite anode. This study provides a facile method for preparing epoxy-based electrolytes for high-performance lithium-ion batteries (LIBs).

Keywords

• gel polymer electrolytes
• tri-epoxide monomer
• LiFSI
• in situ cationic polymerization
• lithium-ion batteries