Mechanical and Corrosion Properties of Mg–Gd–Cu–Zr Alloy for Degradable Fracturing Ball Applications

Abstract

Generally, excellent mechanical properties of Mg alloys are desired, but their rapid degradation properties are seldom utilized. Petroleum fracturing techniques are required to take full advantage of this rapid degradation. Therefore, we have prepared an as-extruded Mg–6.0Gd–1.2Cu–1.2Zr (wt.%) alloy and treated it with peak aging to analyze its potential as a degradable fracture ball. The results show that the as-extruded alloy mainly consists of an α-Mg matrix, second phase, and large elongated α-Mg grains (LEGs). After aging, the LEGs undergo static recrystallization, which improves the mechanical properties of the alloy, and a lamellar long period stacking ordered (LPSO) phase is observed. Under simulated underground temperature conditions (93 °C), the ultimate tensile strength and elongation of both as-extruded and as-aged alloys are over Ȧ MPa and 11.1%, respectively, and the ultimate compressive strength and elongation of both alloys are over 336 MPa and 16.9%, respectively. The corrosion rate of the as-extruded alloy in 3 wt.% KCl solution at 93 °C reaches 1660.8 mm/y by mass loss test, and that of the as-aged alloy increases to 1955.1 mm/y. The atomic force microscope analysis result confirms that the second phase shows the highest corrosion potential, followed by the lamellar LPSO phase and α-Mg matrix. The as-extruded and as-aged Mg–6.0Gd–1.2Cu–1.2Zr alloy with good mechanical properties and a high corrosion rate in this work shows promising potential for degradable fracturing ball applications.

Keywords

• Mg–Gd–Cu–Zr alloy
• aging
• extrusion
• mechanical properties
• corrosion
• atomic force microscope