AIP Advances (Jan 2018)

Spontaneous Rayleigh-Brillouin scattering spectral analysis based on the Wiener filter

  • Tao Wu,
  • Jingcheng Shang,
  • Chuanyin Yang,
  • Xinyi Zhang,
  • Huan Yu,
  • Qibo Mao,
  • Xingdao He,
  • Zhongping Chen

DOI
https://doi.org/10.1063/1.5001879
Journal volume & issue
Vol. 8, no. 1
pp. 015210 – 015210-12

Abstract

Read online

In this paper, a spontaneous Rayleigh-Brillouin scattering spectrometer is developed to measure the gaseous spontaneous Rayleigh-Brillouin scattering profiles over the pressure range from 1 to 5 atm for a wavelength of 532nm at a constant room temperature of 296K and a 90o scattering angle. In order to make a direct comparison between the experimentally obtained spectrum and the theoretical spectrum calculated from the Tenti S6 model, the measured spontaneous Rayleigh-Brillouin scattering signal is deconvolved by the Wiener filtering. The purpose is to remove the effect on the spectrum by the transmission function of the Fabry-Perrot scanning interferometer. The results of the comparison show that the deconvolved spectra are consistent with the theoretical spectra calculated from the Tenti S6 model, and thus confirm that the deconvolution based on the Wiener filter is able to process the measured spectra and improve the spectral resolution. Some factors that influence the accuracy of deconvolution are analyzed and discussed. At the same time, another comparison between the raw experimentally obtained spectra and the theoretical spectra calculated by convolving the Tenti S6 model with instrument function of the measurement system is performed in the same experimental condition. The results of the two comparisons show that, compared with the raw experimentally obtained spectrum, the deconvolved spectrum matches the theoretically calculated spectrum more accurately under lower pressure (≤2atm) than under relative higher pressure (>2atm).